1.4. Installation on FreeBSD¶
1.4.1. Installation¶
Use the pre-built binary packages to install CouchDB:
pkg install couchdb3
Alternatively, it is possible installing CouchDB from the Ports Collection:
cd /usr/ports/databases/couchdb3
make install clean
Note
Be sure to create an admin user before starting CouchDB for the first time!
1.4.2. Service Configuration¶
The port is shipped with a script that integrates CouchDB with
FreeBSD’s rc.d service framework. The following options for
/etc/rc.conf or /etc/rc.conf.local are supported (defaults
shown):
couchdb3_enable="NO"
couchdb3_user="couchdb"
couchdb3_erl_flags="-couch_ini /usr/local/libexec/couchdb3/etc/default.ini /usr/local/etc/couchdb3/local.ini"
couchdb3_chdir="/var/db/couchdb3"
After enabling the couchdb3 service (by setting
couchdb3_enable to "YES"), use the following command to start
CouchDB:
service couchdb3 start
This script responds to the arguments start, stop, status,
rcvar etc. If the service is not yet enabled in rc.conf, use
onestart to start it up ad-hoc.
The service will also use settings from the following config files:
/usr/local/libexec/couchdb3/etc/default.ini/usr/local/etc/couchdb3/local.ini
The default.ini should be left read-only, and will be replaced on
upgrades and re-installs without warning. Therefore administrators
should use default.ini as a reference and only modify the
local.ini file.
1.4.3. Post Install¶
The installation is not complete. Be sure to complete the Setup steps for a single node or clustered installation.
Also note that the port will probably show some messages after the installation happened. Make note of these instructions, although they can be found in the ports tree for later reference.